Page 1 of 1
Engine wiring harness firewall grommet
Posted: Wed Aug 24, 2011 7:03 pm
by Blaise
Does anyone know where I could find replacement grommets for the two firewall passthroughs on the engine wiring harness to ECU?
These are the two huge ones and lead from the engine bay to the glove box.
Posted: Wed Aug 24, 2011 8:01 pm
by Keith
Any clue what the part number is?
Posted: Wed Aug 24, 2011 8:20 pm
by Blaise
Keith wrote:Any clue what the part number is?
It is not listed individually on realoem, as it came with the harness.
Posted: Wed Aug 24, 2011 8:29 pm
by Keith
Hmmm....Picture?
Posted: Fri Aug 26, 2011 10:25 am
by Blaise
engine wiring harness firewall grommets
Posted: Fri Aug 26, 2011 12:01 pm
by bsheridan
Try going to restoration specialties and looking under grommets in their catalog. You may have to improvise from what they have.
www.restorationspecialties.com
Re: engine wiring harness firewall grommets
Posted: Fri Aug 26, 2011 1:40 pm
by Blaise
bsheridan wrote:Try going to restoration specialties and looking under grommets in their catalog. You may have to improvise from what they have.
www.restorationspecialties.com
That was worth a try, but this is what they told me when I showed them what I needed.
"Sorry, but unfortunately, we do not have anything close to this."
Posted: Fri Aug 26, 2011 8:59 pm
by T.Hanson
If your search for something close, workable proves difficult, I'm confident there's a black rubber glue and the SEM ( brand, flex fillers) website to save the grommet carcass you have.
An exercise in patience, and spendy maybe, but very doable.
