Posted by Peter Florance on February 25, 2000 at 21:16:23:
Thanks to Beamher Bob who got me diagrams I can actually read:
You'll need a 12 power source, one wire connected to positive (+12V) and two wires connector to negative (ground). You should fuse this setup unless you're confident of what you are dealing with. I used a little 3 amp supply so maybe around that.
Connect one of the ground wires to the brown lock motor wire. Then connect +12V to white and the other ground to blue. If it doesn't move it may already be at the end of it's travel for that direction. So reverse the blue and white wires. If it still doesn't move, the motor assy is bad and you may try opening it up like I did and clean the limit switch contacts. As you connect the wires one way and then the other, the motor should move from one position to the other. It should stop on it's own in each direction when finished.
Got it??
Peter