Tires and wheel alignments?
-
canada karl
- Posts: 1065
- Joined: Tue Jan 06, 2009 3:50 pm
Tires and wheel alignments?
Can anyone recommend a good mid range tire for summer use? Do our cars require a "four wheel" alignment? That is does the rear end need to be brought into spec?
1976 530i. BMW 59 Triumph TR3A(rolling resto). 67 Triumph TR4A(salvageable). 86 900S Winter car
My understanding is that in our stock form, only the front wheel toe can be adjusted. The rear cannot be adjusted.
But you could do what I did and add camber adjusters front and back and get it aligned as you wish.
I use Bridgestone Potenza RE760 sports and like them. But I am running a 16" rim.
But you could do what I did and add camber adjusters front and back and get it aligned as you wish.
I use Bridgestone Potenza RE760 sports and like them. But I am running a 16" rim.
1977 BMW 530i
1973 R75/5 BMW (motorcycle)
1973 R75/5 BMW (motorcycle)
-
BimBim2oo2
- Posts: 268
- Joined: Sat Jul 07, 2012 12:49 pm
- Location: Boise, Idaho
I believe the number is 1/16" toe in,...to start the silliness in a 30 year old sedan, designed for 65 m.p.h. on the highway and 25 in the neighborhood.
Struts up front. Designed for, the above handling requirements. With a race car everything pretty much begins with a rigid, no flex frame center. This to allow the adjusting of all the suspension components as free from the mysterious twisting factors of frame flexing as possible.
Struts, frame components attached with (old) rubber bushings, tie rods, center link, pitman arm bushing age. A unibody. Knock ourselves out.
Eibach lowering springs with sport shocks tickle my fancy for the Walter Mitty racer look, knowing there's a tire cost to pay. Without moving the lower suspension pivot points the increased (negative) camber eats the inside tread.
Weld all body seams, add a roll cage for frame stiffness. Coil overs, strut braces, bigger stabilizer bars, new rubber or urethane, camber plates,...
Maybe I'll just swap the tires side to side eventually, take the 528 to the store and buy a Vintage Formula Ford if I want to race.
Struts up front. Designed for, the above handling requirements. With a race car everything pretty much begins with a rigid, no flex frame center. This to allow the adjusting of all the suspension components as free from the mysterious twisting factors of frame flexing as possible.
Struts, frame components attached with (old) rubber bushings, tie rods, center link, pitman arm bushing age. A unibody. Knock ourselves out.
Eibach lowering springs with sport shocks tickle my fancy for the Walter Mitty racer look, knowing there's a tire cost to pay. Without moving the lower suspension pivot points the increased (negative) camber eats the inside tread.
Weld all body seams, add a roll cage for frame stiffness. Coil overs, strut braces, bigger stabilizer bars, new rubber or urethane, camber plates,...
Maybe I'll just swap the tires side to side eventually, take the 528 to the store and buy a Vintage Formula Ford if I want to race.
