I know the location of the bolt that uses the O ring ( Haynes photo ) but the parts drawing is confusing. For fun, what came off had a thicker steel washer where the O ring, red fiber washer should have been and one wave washer.
Am I correct with 12110002735 O ring, against duck plate, then wave washer, bolt. All other bolts use wave washers. Use gasket goo on plate side of gasket.
Thank you,
The duck: washers, etc.
Correct. I also use blue locktite to make sure nothing loosens up especially given how difficult it is to get back there with the engine in place.Am I correct with 12110002735 O ring, against duck plate, then wave washer, bolt. All other bolts use wave washers. Use gasket goo on plate side of gasket.
Mike W.
02 525ita. Wife's, aka grocery getter
02 530i. New to the fleet, 3 pedals.
03 QX4, AKA the Datsun. Finally got the 4WD vacationmoble to stop smoking.
07 Xterra. Still on the DL, a purchase from hell.
02 525ita. Wife's, aka grocery getter
02 530i. New to the fleet, 3 pedals.
03 QX4, AKA the Datsun. Finally got the 4WD vacationmoble to stop smoking.
07 Xterra. Still on the DL, a purchase from hell.