Page 1 of 1
need advise on this two cylinders
Posted: Thu Mar 25, 2010 10:23 am
by fidosd9
would a hone job do or i am !@##$ and need to re-bore
Posted: Thu Mar 25, 2010 1:00 pm
by anthony
If you can hone yourself or at no expense, then hone and recalibrate. You can always bore later.
Posted: Fri Mar 26, 2010 1:27 am
by KenB
Uh, I'm gonna say the latter, sadly.
On the other hand, maybe I am completely wrong.
Ken
Posted: Fri Mar 26, 2010 1:14 pm
by T.Hanson
What are your end plans ?
Rather large investment in time to get it apart, all apart, for either honing or boring. To begin the daisy chain of, " While it's this far, replace this and that.
Wild guess the enthusiasts will advise finding a 3.5, if you're thinking anything but hand sanding the lumps and pressing on. Too many good 2.8 short blocks laying around to dump money and time totally rebuilding one.