Unable to diagnose

Post your E12 technical questions and comments here. Please, no off-topic posts.

Moderators: Mike W., Pierre

Post Reply
crubio
Posts: 4
Joined: Thu Jun 13, 2013 8:24 pm

Unable to diagnose

Post by crubio »

Hello everyone. I have a most unusual problem with my 1976 530i; I hope that someone has run into this situation before.

Most of the time, the car will start normally. By that I mean that the starter motor will spin quickly, and the engine will start. While I am cranking, the tach needle stays at 0 until the engine fires, then it goes to 1000 rpm.

Occasionally, the starter motor will turn much slower, and the tach needle will jump between 0 and 5000 rpm while I am cranking. Eventually, the cart starts.

I have a new battery, new starter, new alternator, new battery cables, cap, rotor, plugs and ignition wires.

Since the car does this occasionally, it is difficult to diagnose. Any thoughts might be appreciated. I checked my relays and cleaned the contacts. Could the combo relay be going bad, so the starter does not get all 12v from time to time.?

Thank you in advance, Carlos Rubio
User avatar
Mike W.
Posts: 2889
Joined: Wed Aug 30, 2006 12:12 am
Location: Sonoma County

Post by Mike W. »

If the starter is turning slower, start with the basics. Remove, clean and replace the battery cable connections at the battery, starter and ground. I don't care if they look nice and clean, you can't see resistance, remove, clean and replace.
Mike W.



02 525ita. Wife's, aka grocery getter
02 530i. New to the fleet, 3 pedals.
03 QX4, AKA the Datsun. Finally got the 4WD vacationmoble to stop smoking.
07 Xterra. Still on the DL, a purchase from hell.
crubio
Posts: 4
Joined: Thu Jun 13, 2013 8:24 pm

Post by crubio »

That was my first thought. Every connection has been cleaned, but the intermittent problem still persists. Thank you.
Post Reply