Greetings all. I am fixing up the car to go on tour around the US for about 6 months. One of the things that needs attention is the output flange on the 5 speed transmission. It has a deep groove where the seal lip rides. I am considering replacing the part or using a speedy sleeve. I found part number 23211202746 very cheap online. Real oem shows this with a note "D=10mm" and an alternative part number 23211203061 with a note "D=12mm". My question is this... does D refer to the size of the bolt holes for attaching the flex disc? My e12 is a 2/1981 528i. Any illuminating input will be much appreciated.
Thanks!
5 Speed output flange 10mm or 12mm?
That would be the bolt holes, very early cars like 2800 Bavs were 10MM, later ones have been 12MM.
Mike W.
02 525ita. Wife's, aka grocery getter
02 530i. New to the fleet, 3 pedals.
03 QX4, AKA the Datsun. Finally got the 4WD vacationmoble to stop smoking.
07 Xterra. Still on the DL, a purchase from hell.
02 525ita. Wife's, aka grocery getter
02 530i. New to the fleet, 3 pedals.
03 QX4, AKA the Datsun. Finally got the 4WD vacationmoble to stop smoking.
07 Xterra. Still on the DL, a purchase from hell.
-
alotawatts
- Posts: 438
- Joined: Wed Jan 07, 2009 3:52 am
- Location: Seattle WA
Re: 5 Speed output flange 10mm or 12mm?
I would want to tow a small trailer load of spare parts....Freddy wrote: I am fixing up the car to go on tour around the US for about 6 months.
Three E12's and one R27
