Windshield Trim Installation

jrwilliams · Post by **jrwilliams** » Sat May 12, 2012 11:31 pm

Does the metal chrome trim at the bottom of the front windshield need to be installed inside the rubber gasket BEFORE the windshield and gasket are put in or can it be installed afterward?

I just had the windshield replaced and the chrome piece is not all the way in at the bottom edge of the lower chrome piece.

Thanks for the advice.

T.Hanson · Post by **T.Hanson** » Sun May 13, 2012 10:41 pm

I've not replaced a windscreen. Taking a flying guess, the glass is surrounded by a large black rubber frame/gasket that fits it in the body. I believe the chrome clips in around the outside of that, and the center (silver) strip pushes into the black rubber frame.

If you had the windshield installed professionally, take it back and have them finish their work. If the professional removing the old glass didn't pay attention to how it came apart, it's up to them to fly to Germany and find out how it goes back together. WITHout cracking or leaking.

For further reference you can save time waiting for replies by Google Searching topics on this site. Tons of posts are waiting on every subject, as are the FAQ's.

Jeff Dennis · Post by **Jeff Dennis** » Tue May 15, 2012 9:12 pm

I'm 90% sure the glass is installed with the (plastic)chrome surround and the metal clips in place before the process of slipping the inner seal in place from inside the car. I will double check the factory manual.

Jeff Dennis · Post by **Jeff Dennis** » Wed May 16, 2012 9:31 am

The manual instructs to install the trim strips and clips before the windshield is installed. If you need the pages from the manual let me know I can scan them.

Mike W. · Post by **Mike W.** » Thu May 17, 2012 9:35 pm

I usually install the aluminum at the bottom before I put the windshield in. I always install the plastic trim after. Get it at least somewhat warm in the sun and use cream type waterless hand cleaner as a lube. It's a little work, but not bad.

bizz · Post by **bizz** » Sun May 20, 2012 4:16 am

Mike W. wrote:I usually install the aluminum at the bottom before I put the windshield in. I always install the plastic trim after. Get it at least somewhat warm in the sun and use cream type waterless hand cleaner as a lube. It's a little work, but not bad.

Good to know, i'm getting mine professionally installed but i'll impart this wisdom just incase